alproof
unload_ramp_sensor
uramps
Trendsetter_400/800_Proofing
Enables/disables the unload ramp sensor in firmware versions 1.40 and higher.
This sensor is sampled at the start of unloading of proof media onto the cassette
for a baseline level. When the vacuum roller pushes the media out, the sensor
is sampled until a threshold over the baseline has been attained indicating that
the media is over the sensor.
byte
1
1 to 1 (no units)
Possibly due to changes in proofing media, the unload ramp sensor may experience
difficulty detecting media resulting in unload errors. If the device experiences
this behavior, the unload ramp sensor should be disabled. Note that the "mask range on"
command must be used in order to modify this parameter.
cal